When you use a solar battery as a source of electricity, you will need a charge current regulator in accordance with the charge voltage. After all, the charging controller for the UKC LD-530A Solar Panel at 30 A provides a long battery life and contributes to the preservation.

The controller for charging the UKC LD-530A solar battery has several modes of operation, two of which are interrupted during charging, one of them is invariably the interval of triggering the RVN intelligence during charging. By pulsation, it is possible to identify how the charging process itself takes place. The device charges not bad, but the frequency is small for a faster charging and desulfatation mode. The device has a sound signal that warns about the absence of voltage.

The device is made in a very good case, which is designed specifically for this board! The board inside the device is made very well, since the soldering is done by 5 points, and the protection of the board is in the form of varnish, this is the first controller that is so well filled with it. The device board has revision 1.0. The firmware in it is quite modern, which means that this charging controller for the UKC LD-530A Solar Panel is not stamped continuously in one case and with one firmware.

Main technical characteristics:

- Model: LD-530A;

- Supply voltage: 12V, 24V;

- Maximum load current: 30.0(A);

- Maximum input voltage: 100V;

- Controller Type: PWM;

- Electronic protection: Against short circuit and against incorrect polarity;

- Operating temperature: -20 °C +55 °C;

- Degree of protection of the device: IP32;

- Dimensions of the liquid crystal display:     45 x 25 mm;

- Overall dimensions: 160 x 85 x 35 mm;

- Weight: 150 grams.

Complete sets:

- Controller for CHARGING the UKC LD-530A 30A solar battery;

- Instructions;

- Packaging.